Finger joint box generator

A closed box with finger joints on every edge, sized for your material and your laser's kerf. Each joint is checked before you download the file.

1 Your laser’s kerf

Not sure? Cut the test card first

Cut both pieces from the material you will use. Try each tooth in the notch with the same label. The pair that slides in snugly is your kerf.

2 Your box

Make
Top
These sizes are
Material thickness
Joint fit

joints close by hand

3 Download

  • Assign cut, score and engrave settings to the red, blue and black shapes.
bottomtopfrontbackleftright
  • Files check out: true size in mm, every cut closed, no line cut twice, parts at least 3 mm apart.
  • Joints check out: the 6 parts, put back together, fill every wall exactly once (2,431 cells tested).
  • Each joint is cut for a kerf of 0.15 mm with no extra play.

What a finger joint is

A finger joint, also called a box joint, interlocks two boards with rectangular fingers: every finger of one board sits in a slot of the other. On a laser it is the strongest joint you can cut in one pass, and it gives a box its typical stepped corners. It only works if the fingers and slots are the same width after cutting, which is why the kerf matters so much.

How the fingers are laid out

Each edge of the box is split into an odd number of equal fingers, three at least. The two walls take turns, and the wall that owns the first finger also owns the last, so no edge ends in a thin sliver. Where three walls meet at a corner, the bottom or top owns the corner block. The generator builds the whole box in 3D this way and traces each flat part from it, so the parts fit each other by construction.

From the file to a closed box

  1. Cut the kerf test card from the same sheet and enter the kerf you read from it.
  2. Measure the sheet thickness with calipers and enter it; the presets are nominal sizes only.
  3. Download the SVG for your laser program and cut all parts in one job.
  4. Press the walls onto the bottom first, then add the top.

The assembled tab shows the same parts in 3D; drag “Pull apart” to see how every finger meets its slot. If you need a box that opens, choose the lift-off lid. For more box styles and trays, go back to the laser cut box generator, or measure your kerf first.

Questions

How wide are the fingers?

About three times the material thickness, at least 8 mm, adjusted so every edge has an odd number of equal fingers. Both ends of an edge then belong to the same wall, which keeps the corners strong.

Why do the corners sometimes show a small notch?

Where three walls meet, one of them has to own the corner. The bottom and top take it, so the side walls are notched there. The corner is still filled: the 3D check proves every corner is filled exactly once.

Can I make the box in inches?

Yes. Switch to inches at the top of the settings. The files are always written in millimetres, which every laser program reads at true size.

What thickness is 1/8 inch plywood really?

Often 2.9 to 3.2 mm, not 3.175. Measure your sheet with calipers and type the value in “Measured thickness”: the finger depth follows it.