Laser cut tray generator with dividers
An open tray or drawer organiser with crossing dividers that slot together. Pick the compartments, the material and your kerf; every part is checked before you download it.
- Files check out: true size in mm, every cut closed, no line cut twice, parts at least 3 mm apart.
- Joints check out: the 8 parts, put back together, fill every wall exactly once (5,643 cells tested).
- Each joint is cut for a kerf of 0.15 mm with no extra play.
A tray that locks together
Organisers for drawers, tools, screws or craft supplies are some of the most useful things a laser makes, and some of the most annoying when the dividers wobble. In this tray every divider is held twice: its tabs pass through slots in the outer walls, and where two dividers cross, each is slotted halfway so they lock into each other. The walls themselves join with finger joints, like a box.
Setting the compartments
“Compartments across” splits the width, “compartments deep” the depth, into equal spaces. The size you enter can be the inside of the tray or its outside: choose inside if the tray has to hold something of a known size, outside if it has to fit a drawer. The dividers are as tall as the walls, so the tray has a flat top edge.
Checked before you cut
The tray is modelled in 3D before any part is drawn: walls, floor and dividers. After the parts are traced, compensated for your kerf and laid out on the sheet, the page reads the file back and puts the parts together again. The tick under the preview says that every wall and every divider is filled exactly once, with no gaps and no overlap, including where the tabs pass through the walls.
Tips for a clean result
- Measure your kerf with the kerf test card on the same sheet you will use.
- Plywood varies from sheet to sheet: measure its thickness and enter the real value.
- Assemble the dividers into a grid first, then drop the grid into the walls before closing the last wall.
Need a box instead of a tray? Use the laser cut box generator.
Questions
How do the dividers hold?
Each divider has tabs that pass through slots in the walls, and dividers that cross are each slotted halfway, one from the top and one from the bottom, so they lock together.
How many compartments can I have?
Up to 12 across and 12 deep, as long as every compartment is at least twice the material thickness wide.
Do I need glue?
With a snug or press fit the tray holds together on its own. A drop of wood glue on the bottom joints makes it permanent.
Can the tray have a lid?
Not yet. For a lidded box use the box generator and choose the lift-off lid.