Laser kerf test card

One small cut tells you your laser's kerf. Cut the comb and the key, find the tooth that slides into its notch snugly, and use that value for every box you make.

1 Your laser’s kerf

Not sure? Cut the test card first

Cut both pieces from the material you will use. Try each tooth in the notch with the same label. The pair that slides in snugly is your kerf.

2 Your box

Make
Top
These sizes are
Material thickness
Joint fit

joints close by hand

3 Download

  • Assign cut, score and engrave settings to the red, blue and black shapes.
bottomfrontbackleftright
  • Files check out: true size in mm, every cut closed, no line cut twice, parts at least 3 mm apart.
  • Joints check out: the 5 parts, put back together, fill every wall exactly once (1,560 cells tested).
  • Each joint is cut for a kerf of 0.15 mm with no extra play.

How the card works

The card has two pieces. The comb has a row of notches and the key a row of teeth, each pair labelled with a kerf value. Notch i is drawn narrower by that value and tooth i wider by it. When you cut the card, your laser removes its own kerf from both. Only for the pair whose label equals your real kerf do the tooth and the notch come out exactly the same width: that pair slides together snugly, the pairs before it are tight and the pairs after it are loose.

Cutting it

  1. Open “Not sure? Cut the test card first” above; the default range is 0.05 to 0.40 mm in steps of 0.025 mm.
  2. Download the card and cut it from the sheet you will use, with your normal cutting speed and power.
  3. Try each tooth in the notch with the same label. Use a light push, no hammering.
  4. Enter the value of the snug pair as your kerf, then design your box below.

Why one value is enough

Some generators ask for half the kerf, or for separate values per joint. Here you enter the kerf exactly as the card shows it. The generator moves every cut line out by half of it, so after cutting both sides of every finger and slot are where they were drawn. The joint fit (loose, snug or press) is a separate setting, so you never have to fake the kerf to make a joint tighter.

The labels are engraved as simple seven-segment digits, so the card works in any laser program without fonts. When you know your kerf, use the box generator or the tray generator.

Questions

What is kerf on a laser cutter?

The width of material the beam removes along a cut. It depends on the laser, the lens, the focus, the power and speed, and the material, so the same machine can have a different kerf on plywood and on acrylic.

What if two teeth fit?

Take the smaller value for a tighter joint or the larger one for an easier fit. You can also run the card again with a smaller step around those values.

What if no tooth fits?

Widen the range: start lower if even the first tooth is too loose, or go higher if the last one is still too tight. Check focus first: a laser out of focus cuts much wider.

Do I need to measure kerf for every material?

Yes, ideally once per material and thickness, with the speed and power you will use. Write the value on the sheet stack.